This image has been collected from the source mentioned, and we fully acknowledge and credit the original provider for their work. Following this acknowledgment, the article transitions into the primary report, which has been independently written by our team at this news portal. : File Photo We should use the water heater rod very carefully.
Extreme caution should be taken while using electrical devices. Be it summer or winter, different types of electrical equipment are used. Room heaters, water heaters and geysers are used extensively during the winter season. Now that winter has come once again, there is a need for hot water. To avoid cold, geyser or water heater rod, which we also call immersion rod, is used extensively to heat water in most of the houses. If you are also going to use it, then there is useful news for you.
Actually geysers are quite expensive and not everyone can afford them. In such situations, many times people use water heater rods to heat water. Water heater rods heat water but they are also quite dangerous. Therefore, if we are a little careless in its use, it can cause huge losses. These are more risky than geysers. If you use an immersion rod, you should keep a few things in mind.
Never make this mistake with immersion rod
- If you are going to use a water heater rod to avoid cold, then you should avoid using old heater rods.
- Always use water heater rods in a plastic bucket. Apply it on the iron bucket even by mistake.
- Switch on the water heater rod only when you put it in water. Do not touch the bucket after switching on.
- If there is less water in the bucket, never pour water into it while the heater is on. Due to this you may get severe electric shock.
- Many times it is seen that when needed, people start taking hot water from the bucket as soon as the heater is on. Don't make such a mistake even by mistake.
- If the water has become hot and you have switched off the water heater rod, do not remove it from the water immediately, remove the rod from the water only after 15-20 seconds of switching off.
- Many people keep the water heater rod on for hours. You should never make such a mistake. If you are heating water with a heater rot, then heat it at the optimal temperature only.
- If you are going to buy a new immersion rod, then buy only ISI marked heaters. Buy only immersion rods with voltage between 1500-200 watts and 230-250 watts.
- Many people use the immersion rod in less than half a bucket of water. You should never make such a mistake. Place enough water in the bucket so that the rod is completely submerged.
Information- 200MP camera, 256GB storage, price of Samsung Galaxy S23 Ultra increased in Flipkart
Image Credit: India_Tv.